A fence made from fence panels can be a great way to add privacy to your yard. They’re also easy to assemble and are less expensive than building the entire fence from scratch.

The first step in making a fence from fence panels is to plan the length and width of the fence. This will help you determine the best wood and rails for your project.

Next, you’ll need to gather the materials for your fence. This can include a variety of things, from wood to metal pieces. You may even be able to find some supplies in your local home improvement store.

Once you’ve gathered all of your materials, it’s time to start the actual construction process. This will take some patience and a lot of attention to detail, so be sure you have plenty of assistance.

Whether you’re constructing a simple fence or a more complicated one, the basic steps are the same. The key is to make the right decisions for your property and budget.

If your home has a yard that slopes, you might want to consider using staggered panels to create a more level fence. However, this will result in gaps at the bottom of the fence where dogs and critters can get out, so it might be best to stick with simple posts and pickets.

After you’ve planned out your fence and collected all of your materials, it’s time for the real work. You’ll need a few tools to get started on this job.

A post hole digger is a useful tool for this project, as you’ll need to dig holes for the posts. These holes need to be at least a third of the height of each fence post, plus a bit more depth and three times the width of the post for extra strength.

You’ll also need gravel to fill the bottom of each post hole for drainage. You’ll need to use a hose to fill the holes, but you can also wait until they’re set in concrete before adding the gravel.

Once the posts are in place, you’ll need to pound them into the ground. You can use a manual pounder or an electric hammer drill with a post pounder attachment, depending on your preference.

Another essential tool for this project is a tamping pole. Tamping is a process that helps to evenly distribute pressure on the soil to ensure the fence posts are plumb. This tool can be purchased at most hardware stores or online for about $20.

If your yard is flat, then you should be able to install the fence in a straight line between each post. If it’s sloped, you’ll have to stagger the height of each panel so that they fasten evenly to the posts, but this will also make your job easier.

Before you begin drilling, draw guidelines across each board to make sure they’re in line with the fence panels that go before them. This will prevent your panel from becoming crooked or off-balance.